Filter
Top Products
26
LZ196 (E/F) Web 213:276
Chapter 4: Setting up your TV
Programming channels into the
TV’s channel memory
When you press < or , on the remote control or TV control
panel, your TV will stop only on the channels you programmed
into the TV’s channel memory.
Follow the steps below to program channels into the TV’s
channel memory.
Programming channels automatically
Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are
programmed automatically, you can manually add or erase
individual channels in the channel memory.
Note:
• You must configure the antenna input source before
programming channels (- page 25).
• If the Antenna 1 input signal type is set to Cable, the
automatic channel programming process erases channels
that were previously programmed into the TV’s memory.
• If the Antenna 1 input signal type is set to Antenna, the
automatic channel programming process adds newly found
channels to the existing set of programmed channels
(and does NOT erase channels that were previously
programmed into the TV’s memory). To remove an antenna
source channel from the memory, you must manually
delete it.
• To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
• Programming channels when the antenna input is
configured for Cable will take substantially longer than when
the antenna input is configured for Antenna. This is normal;
however, once channel programming is finished, you should
not have to repeat the programming process again unless
your Cable TV service lineup changes significantly.
• If you have a CableCARD
™
inserted, channel programming
for the ANT 1 input is disabled because the CableCARD
™
automatically loads the Cable channel list into the TV’s
channel memory. See the Installation Guide for details on
CableCARD
™
.
To program channels automatically:
1 Configure the antenna input sources, if you have not
already done so (
- page 25).
2 Press Y and open the Setup menu.
3 Highlight Installation and press T.
4 (A new set of Installation menu icons will appear, as
shown below.) Open the Terrestrial menu, highlight
Channel Program, and press T.
5 Highlight ANT 1 (or ANT 2) and then press T to start
automatic channel programming.
The TV will automatically cycle through all the antenna
channels, and store all active channels in the channel
memory. While the TV is cycling through the channels,
the message “Scanning channels, please wait” appears (as
shown above).
6 To cancel channel programming, press O on the remote
control (or highlight Abort in the on-screen display and
press T).
When channel programming is finished, press < or , to
view the programmed channels.
CH RTNENTER
EXIT
Navigate
Select
Back Exit
Installation
Sleep Timer
PC Settings
On/Off Timer
Setup
PC Audio
Auto
2 Sec
HDMI 1 Audio
No
Slide Show Interval
CH RTNENTER
EXIT
Navigate
Select
Back Exit
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
ANT 1 Antenna
Scanning channels, please wait ...
Abort
52%
LZ196_EN.book Page 26 Tuesday, August 1, 2006 6:04 PM