Filter
Top Products
Introduction
Recording Playback Editing
Introduction
Connections
Basic Setup
Function Setup Others
19EN
Installing batteries in the remote
control
About the remote control
Preparation of the remote control
■ Install two R6 (AA) batteries (supplied) into the
remote control, carefully match with the
polarity indicated inside the battery
compartment.
1
Open the cover.
2
Insert batteries.
Make sure to match the + and - on the
batteries to the marks inside the battery
compartment.
3
Close the cover.
■ Keep in mind the following when using the
remote control:
● Make sure there is no obstacle between the remote
control and the remote control sensor on the unit.
● Use within the operating range and angle as
shown.
● Remote control operation may become unreliable if
the remote control sensor of the unit is being
exposed by the strong sunlight or fluorescent light.
● Remote controls for different devices can interfere
with each other. Be careful when using remote
controls for other equipment located close to the
unit.
● Replace the batteries when the operating range of
the remote control reduces.
● The maximum operable range as follows:
- Line of sight:
approximately 7 m
- Either side of the centre:
approximately 7 m within 30 degrees
REC MODE
REC
PROGRAM
ON/STANDBY
I
/
y
Notes:
• Incorrect use of batteries can result in hazards such as
leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the + and - ends of each battery match the
indications inside the battery compartment.
• Remove batteries if the remote control will not be used for
an extended period of time.
• When disposing used batteries, please comply with
governmental regulations or the public instructions for
environmental protection that apply in your country or
area.
• Do not recharge, short-circuit, heat, burn or disassemble
batteries.