Filter
Top Products
Recording
54 EN
Timer Recording (cont’d)
4) With start time and the recording mode
highlighted, press [ENTER].
5) Set the desired start time using [K / L / { / B].
• Change the value for the hour using [K / L], then
confirm with [
B].
• Change the value for the minute using [
K / L], then
confirm with [
B].
• The hour can be selected between 0 to 23.
• If you wish to go back to the left, press [
{].
6) Select the desired recording mode using
[K / L], then press [ENTER].
See page 36 for details.
7) With “To Standby Mode” highlighted, press
[ENTER] again.
In a second, the unit will be turned off automatically
as it goes into the Satellite Link standby mode.
• Until the time you set in “Start”, the clock will
appear on the front panel display.
• “sat” will appear on the front panel display at the
start time.
To cancel the Satellite Link function while in the
Satellite Link standby mode:
Press [I/
y ON/STANDBY] to turn on the unit.
To cancel the Satellite Link function while the
Satellite Link Timer Recording is in progress:
Press [STOP C] on the front panel of the unit.
Satellite Link
To Standby Mode
Start
17:30 SP
Mode
Satellite Link
To Standby Mode
Start
17:30 SP
Mode
Notes
• If you have not set the clock, the clock setting window will
appear at step 3. Follow step 3 in “Manual Clock Setting”
on page 31.
• You cannot set the End time for the Satellite Link Timer
Recording on this unit.
• Recording picture will be distorted if the copy protection
signal is being detected during Satellite Link Timer
Recording.
• When a regular Timer Recording and the Satellite Link
Timer Recording are overlapped:
Example 1
Timer Recording
Satellite Link
Actual Recording
Example 2
Timer Recording
Satellite Link
Actual Recording
Example 3
Timer Recording
Satellite Link
Actual Recording