Filter
Top Products
Recording
Playback EditingIntroduction Connections
Basic Setup
Function Setup Others
51EN
The error number appears on the Timer Programming
list.
The error programme will be displayed in grey
with an asterisk and have an error number.
The error numbers indicate:
E1–E22, E37–E39: Recording error
E23–E24: Unrecordable disc
E25: • Copy prohibited programme
• Cannot record because of the NTSC / PAL-
60 signal is received.
E26–E28: Copy prohibited programme
E29: Disc protected
E30: Disc full
E31: Already recorded 99 titles (Video mode)
E32: Already recorded 99 titles (VR mode)
E33: Already recorded 999 chapters
E34: No space for Control Information
E35: PCA (Power Calibration Area) full
E36: Already finalised Video format disc
E40: • There are some unrecorded parts due the
overlapped timer programmes.
• Recording did not start at the start time.
E41: Power failure
E42: No disc
The error programme will be deleted once you
check the error in the programme list, or once you
cancel the timer-standby mode and re-enter it.
Press [CLEAR] to erase the selected programme.
Checking, cancelling, or
correcting the timer programming
information
In the following example, No. 5 timer programming
overlaps on No. 1 and No. 6 timer programmes. In such
a case, you should correct the programme time to clear
the overlap.
1) Press [I/y ON/STANDBY] so that the icon
disappears from the front panel display.
2) Press [TIMER PROG.].
Timer Programming list will appear.
3) Check the information on the list to be edited.
4) To clear the timer programming, select the
desired programme using [K / L], then press
[CLEAR].
To correct the timer programming
1) Select the desired programme using [K / L], then
press [ENTER].
2) Correct the timer programming using
[K / L / { / B].
3) Press [ENTER] again.
5) Press [TIMER PROG.] to exit.
6) Press [I/
y ON/STANDBY] to return to the timer
standby mode.
Note
• If a timer recording is proceeding, that programme is
highlighted in red. In such a case, you cannot select any
other programmes.
Timer Programming
2. ---
3. ---
4. ---
7. ---
8. ---
1. 01/01 12:00 13:00 AV3 XP ON
Date Start End CH Mode
PDC
5. 01/01 12:30 14:00 P02 SP OFF
6. 01/01 13:45 21:00 P12 SEP OFF
Overlap
No.1 6
Timer Programming
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
*
01/01 12:57 1:57 P08 E22 ON
Date Start End CH Mode
PDC
If the timer programming did not
complete correctly