Filter
Top Products
20
DIASSEMBLY
5-1. How to remove the DLP Engine
1) Remove 96-pin connector from the DLP engine.
2) Remove clock connector from the engine.
3) Remove ballast connector from engine.
4) Remove 2 screws of lamp power connector from engine.
5) Remove 5 screws which are used to tighten engine block and remove engine.
5-2. How to install the DLP Engine
1) Place the engine at the right place, locating guide pins to the location holes.
2) Tighten 5 screws so that engine will be securely attached.
3) By using 2 screws, the lamp connecter could be fixed.
4) Connect ballast connector to the engine.
5) Connect the clock connector to the engine.
6) Attach 96-pin connector to the engine, placing correct direction/position of it.