Filter
Top Products
26
ADJUSTMENT
3. Electronics Adjustment or Setting
Selection or adjustment can be performed using optional Remote Control, model CT-90000 or no
obligation, user-risk freeware, 'Cube Commander'.
Remote control CT-9956 (for CRT cubes) can also be used even though the keys are labeled
differently - please refer to the diagram below.
Not all keys are used for adjustment.
Connect the remote control to the REMOTE jack on the projector.
3-1. Input Signal selection
Sources are selected by pressing the relevant source button: RGB1, RGB2, VIDEO or DIGITAL.
The screen will mute for approximately 5-7 seconds following source selection.
Source selection is only possible in Normal Mode.
(To change sources in Adjust Mode it is necessary to press the MODE button first)