Filter
Top Products
16
TUNING
This DVD+VCR is equipped with a frequency synthe-
sized tuner capable of receiving up to 181 channels.
These include VHF channels 2-13, UHF channels 14-69
and CATV channels 1-125.
Auto Channel Programming
1. Choose the SOURCE SELECT option, then use b/B
to select TUNER.
Use b/B to switch among TUNER, LINE1, and LINE2.
2. Choose the AUTO CHANNEL SET option, then use
b/B to find channels.
• The tuner will automatically cycle through all available
channels (TV/CATV) in the area and place them in the
tuner’s memory.
• After the AUTO CHANNEL SET is complete, the
TUNING menu will hide and return to the TV screen
automatically.
3. Make sure the TUNING BAND is set appropriately
(TV or CATV).
• TV : If you are using a standard antenna to receive
channels.
•CATV : If you are using basic cable to receive channels.
To Add or Erase Channels
This feature allows you to add or erase channels from
memory manually.
1. Choose the CH. ADD/DEL option, then use b/B to
select a channel to add or erase.
2. Use ENTER to add or erase the channel.
Repeat steps 1 and 2 to add or erase other
channels.
3. Press VCR MENU to return to the TV screen.
SETUP
FUNCTION OSD
The on-screen display can be turned on or off.
AUDIO MODE
The DVD+VCR has two separate audio playback sys-
tems, the high quality VHS Hi-Fi system and standard
NORMAL mono system. The same audio is generally
recorded on both systems. The VHS Hi-Fi system plays
on separate (left and right) channels, and the NORMAL
system plays monaural sound. The normal track is
always played so the cassette can be played on a
DVD+VCR that does not have VHS Hi-Fi.
BROADCAST TYPE (STEREO / SAP / MONO)
Multichannel Television Sound (MTS) carries stereo
and/or Second Audio Program (SAP) bilingual signals.
Set this display to the desired position when both MTS
stereo and SAP signals are received. When only one of
the MTS signal is received, the DVD+VCR automatically
selects the corresponding receiving mode (Stereo or
SAP) regardless of the selected position. For normal
operation, the display should be in the STEREO posi-
tion. The DVD+VCR will then record a STEREO pro-
gram when available, and record a mono program IF
the program is NOT IN STEREO. For weak STEREO
and/or SAP broadcasts, changing the display to mono
may give clearer sound.
AUDIO OUTPUT (STEREO / LEFT / RIGHT)
Used during playback [when AUDIO MODE (HI-FI/NOR-
MAL) is in HI-FI position] for selecting the audio output
signals from the AUDIO OUT terminals (L ch and R ch),
and RF.OUT. This display setting should normally be left
in the stereo position, so that when a stereo tape is
played, the stereo sound will be heard through the left
and right channels. If a mono tape is played and the
audio output is set to stereo, the same mono sound will
be heard from both left and right channels.
Initial Settings - VCR (Continued)