Filter
Top Products
57
Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
Assigning the corresponding video input for
the optical and coaxial DIGITAL AUDIO IN
terminals
You can assign the specific video input to use with the optical and/or
coaxial DIGITAL AUDIO IN terminals.
To assign the video input:
1. Press MENU, and then press x or • until the AUDIO menu
appears.
2. Press y or z to highlight OPTICAL or COAXIAL (whichever
DIGITAL AUDIO IN terminal you are assigning video to).
AUD OI
SBS
SBS LEVEL
ON
ON
-
50
ON
OFF
SPEAKERS
AUD O OUTI
STABLE
OPTICAL
/V1/V2/V3/HD1/HD2/DVI /PC IN
COAXIAL OFF
SOUND
MAIN
AUD OI
SBS
SBS LEVEL
ON
ON
DVI
-
50
ON
OFF
SPEAKERS
AUD O OUTI
STABLE
OPTICAL
/V1/V2/V3/HD1/HD2/DVI/PC IN
COAXIAL
SOUND
MAIN
3. Press x or • to assign the corresponding video input, as follows:
—:OFF
V1 : VIDEO 1 IN
V2 : VIDEO 2 IN
V3 : VIDEO 3 IN
HD1 : ColorStream HD1 IN
HD2 : ColorStream HD2 IN
DVI:DVI/HDCP IN
PC IN : PC IN
Note:
• When both OPTICAL and COAXIAL are set to OFF (in steps 2 and 3
above), the video inputs are assigned instead to their corresponding
analog audio input terminals. If you set both OPTICAL and COAXIAL
to OFF, you will need to connect standard analog audio cables or you
will not hear any sound with the corresponding video input.
• You cannot assign the same video input to both OPTICAL and
COAXIAL DIGITAL AUDIO IN terminals.
For additional details on digital audio, see “Connecting a DVD player
or DTV receiver/set-top box with digital audio (coaxial or optical)”
on page 14 and “Enjoying the Dolby Virtual TruSurround sound
feature” on page 53.
Displaying on-screen information
Press RECALL to display the following information on-screen:
• Antenna mode (when in TV mode)
• Channel number or video
mode selected
•Time (if set)
• Channel label (if set)
•Stereo or SAP audio status
•V-CHIP rating status
•Picture size
yzx •
MENU
RECALL
ANT
ABCDFULL
STEREO
SAP
TV L VPG–
CABLE9:25
1
6
57HLX82(E)51-58 10/29/02, 10:29 AM57