Filter
Top Products
Hard Disc Drive Play Mode
35
You can navigate in Time Shifting mode and control the audio by using the following remote control keys:
KEY RESULT NOTE
CH +/- Change the channel By default, changing the channel will
erase all Time Shifting required for the
current channel.
0-9 Change the channel
FF Fast Forward (Press to cycle through
4, 8, 32 x speeds.)
Slow Slow Forward (Press to cycle through
1/2, 1/4, 1/8 x speeds.)
Replay Jump back 10 seconds Arrow left key
If you hold the left arrow key for 2
seconds, the unit will jump back 10
seconds
Skip Jump forward 30 seconds Arrow right key
If you hold the right arrow key for 2
seconds, it will jump to the end of the
buffer (live recording)
Mute Mute audio on/off
VOL +/- Decrease/increase volume
Save
In order to save from within the Time Shifting buffer, two options are available:
Option 1:
While viewing a program, press “REC”. This will start saving the segment you are watching. You can extend the amount of
recording time during the saving operation, by pressing “REC”. You will increase the length of the program you are saving
by 30 minutes up to a maximum of 3 hours. Press STOP to indicate the end of the saving operation. The saved part of the
time shifting buffer will be tagged in red.
Option 2:
While viewing a program, press “REC” and hold down for 3 seconds. This will save the entire time shifting buffer. If
“STOP” is pressed, the saving will terminate at that point in the buffer. During the saving operation, pressing “REC” will
increase the length of the program you are saving by 30 minutes up to a maximum of 3 hours. Press Stop and hold for 3
seconds if you want to cancel the entire saving operation.
Notes:
• You cannot change the channel or the source if saving is on-going (the end of the recording segment is either
not entered, or in case of long recordings, it has not been reached). Saving has to be manually stopped fi rst (by
pressing STOP). The product will request you to stop saving fi rst. The segment will be saved on HDD and then
channel or source change can be performed.
• Only one segment in the time shifting buffer can be identifi ed for saving. You cannot store multiple segments.
Once the segment has been saved and registered on title list, this segment (and its preceding video segment) will
be removed from the time shifting buffer.
• The saved program will be removed from the time shifting buffer when Stop is pressed. The unit will save
immediately if the system is powered down.