Filter
Top Products
PAUSE
BUTTON
FAV
BUTTON
2423
Favorite Channel Setup
CUSTOMIZING
Favorite Channel Setup
CUSTOMIZING
Favorite Channel Setup
This is one of RF20’s most desirable features. Once it’s set
up, you can select up to 40 favorite channels with the press
of a button - without the need to remember or type in a
channel number. Let the channel surfing begin!
To access Favorite Channel listings, simply press the FAV
button to display Page 1 of Favorite Channel listings. There
are eight pages of Favorite Channels, with five Channels on
each page, for a total of 40 Channels. Just use the PAGE (
)
( ) buttons to locate the Channel you want to setup. Each
Channel can be setup to be instantly selected with the press
of one button.
To setup a Favorite Channel button, follow these steps:
STEP 1:
Press and hold the MAIN and
ENT (Enter) buttons at the same
time for approximately 3 seconds,
until the word “SETUP” is
displayed at the top of the LCD
screen. This signals that you are
now in setup mode.
STEP 2:
Press the FAV display button.
The top of the display will show
“FAV”. The bottom of the display
will flash “SELECT”
STEP 3:
Use the PAGE ( )( ) buttons
until you locate the name
(i.e.,ABC, CBS, NBC) of the
favorite channel you want to
setup.
STEP 4:
Press the favorite channel
display button you want to setup.
The top of the screen will
change to show the channel
name. The bottom of the screen
displays “STEP0”, indicating that
you have not entered the
channel number yet.
STEP 5:
Press either the TV, SAT or
CABLE Component button (select
the Component you use to enter
channel numbers).
STEP 6:
Press each of the number buttons
for the channel.
Note: If a number is repeated when set-
ting the channel (for example, channel
“33” or “522”), it is usually best to set a
half second delay in between the identi-
cal numbers by pressing the (II) PAUSE
button. Each press of the PAUSE button
increases the delay by a half second.
NOTE: Some brands of television
require an ENT (Enter) command after
the channel numbers.
IMPORTANT:
You now have 30 seconds to perform
the next step while you are in SETUP
mode. If you don’t press a button
within 30 seconds, SETUP will disap-
pear from the screen, signaling that
you have exited setup mode and you
will need to start over.