Filter
Top Products
35 36
Recalling Pre-Programmed
Setup Code Numbers
CUSTOMIZING
CUSTOMIZING
Cloning Other RF20s
Recalling Pre-Programmed Setup Code
Numbers
In case you didn’t write down the Pre-Programmed Code
Numbers that you used to set up your RF20, you can easily
recall them using this simple process:
STEP 1:
Press and hold the MAIN and
ENT (Enter) buttons at the same
time for approximately 3 seconds,
until the word “SETUP” is
displayed at the top of the LCD
touch screen. This signals that
you are now in setup mode.
STEP 4:
Write down the code numbers
as they appear for future refer-
ence. Page 43 of this manual
provides a convenient space for
you to record your code
numbers.
STEP 5:
Return to normal operation by
pressing the MAIN button twice.
STEP 4:
Align the two RF20s head-to-
head, about an inch apart.
STEP 5:
Press the RECV display button
on the unprogrammed RF20 that
you want to setup by cloning.
STEP 6:
Press the SEND display button
on the programmed RF20 that
you want to clone.
STEP 7:
Press the START button on the
unprogrammed RF20, and then
press the START button on the
programmed RF20 that you want
to clone.
STEP 8:
Return to normal operation by
pressing the MAIN button twice.
STEP 2:
Go to Page 2 of the Setup Menu
by pressing the PAGE ( ) button.
STEP 3:
Press the RECAL display button
on the LCD screen. The display
will change to the Recall
screens. The screen automati-
cally switches between four
screens, alternately flashing
Page 1 components and code
numbers, then Page 2 compo-
nents and code numbers.
STEP 2:
Press a PAGE button on each
remote to bring up Page 2 of
Setup and display the CLONE
button.
STEP 3:
Press the CLONE button on each
remote.
IMPORTANT:You now have 30 seconds to
perform the next step while you are in
SETUP mode. If you don’t press a button
within 30 seconds, SETUP will disappear
from the screen, signaling that you have
exited setup mode and you will need to
start over.
Cloning Other RF20s
If you are fortunate enough to own more than one RF20,
you’ll be happy to know that you can easily copy and trans-
fer all the setup from one RF20 to another. Just follow these
easy steps:
STEP 1:
For both the programmed RF20
that you want to clone, and
unprogrammed RF20, press and
hold the MAIN and ENT (Enter)
buttons at the same time for
approximately 3 seconds, until
the word “SETUP” is displayed
at the top of their respective LCD
screens. This signals that both
remotes are now in setup mode.
IMPORTANT:You now have 30 seconds to
perform the next step while you are in
SETUP mode. If you don’t press a button
within 30 seconds, SETUP will disappear
from the screen, signaling that you have
exited setup mode and you will need to
start over.
NOTE: Cloning typically takes about 40
seconds. After successful cloning is com-
pleted, the newly cloned RF20 will flash
“GOOD”.