Filter
Top Products
SURE
BUTTON
37 38
Erasing Learned Buttons, Macros or
Favorite Channels
ERASING COMMANDS
ERASING COMMANDS
Erasing Learned Buttons, Macros or
Favorite Channels
Erasing Commands - Overview
You can erase an individual button with a learned com-
mand, a macro or a favorite channel. You can erase an
ENTIRE Component’s learned command or macro buttons.
You can also erase ALL your learned commands on all
Components or all your macros or favorite channels every-
where.
If you really want a fresh start, it is possible to reset every-
thing to the factory default settings.
Erasing Learned Buttons, Macros or Favorite Channels
STEP 2:
Press a PAGE button to display
Page 2 of Setup.
STEP 3:
Press the ERASE display button
on the LCD screen.
STEP 4:
Press either the LEARN, MACRO
or FAV button. The following
screen appears:
ALL - Erases ALL of the speci-
fied (Learned, Macro or FAV but-
tons everywhere in the RF20)
DEVICE - Erases all learned or
Macro buttons in a single
Component (NOTE: This option
is not available for FAVs.)
KEY - Erases one button only.
STEP 1:
Press and hold the MAIN and
ENT (Enter) buttons at the same
time for approximately 3 sec-
onds, until the word “SETUP” is
displayed at the top of the LCD
screen. This signals that you are
now in setup mode.
IMPORTANT:You now have 30 seconds to
perform the next step while you are in
SETUP mode. If you don’t press a button
within 30 seconds, SETUP will disappear
from the screen, signaling that you have
exited setup mode and you will need to
start over.
STEP 5:
If you press ALL, the RF20 dis-
plays a “SURE?” button. After
the SURE button is pressed, all
the buttons will be erased.
If you press DEVICE, a list of
Components will appear. Press
the Component button that you
wish to erase. The bottom of the
screen will flash ERASE twice,
then ERASED.
If you press KEY, you’ll have to
navigate to the Component and
Page you want using the MAIN,
COMPONENT and PAGE buttons.
Press a button to erase it. The
bottom of the display will flash
ERASE twice, then ERASED.
STEP6:
To return to normal operating
mode, press the MAIN button
four times.