Filter
Top Products
ViewSonic VPW505 15
Picture-In-Picture (PIP) / Split Screen - Con’t
Notes:
PIP mode can only be turned on if the display’s input is set to: AV, S-Video, Component 1and 2. If the dis-
play’s main input is set to RGB or DVI, the PIP and POP will not function.
If the display’s input is set to Component 1 or Component 2, the PIP will only turn on if the input signal
source is compatible with 15KHz signals such as 480i and Y/C
B
/C
R
signals.
When changing input source for sub-pictures to Component 1 and Component 2, only 15KHz compatible
signals such as 480i and Y/C
B
/C
R
will result in a video picture display. If another signal other than 15KHz
is detected, the sub-picture may display distorted video signals.
Once PIP is turned off, the next time you return on PIP mode, the position of the sub-window will start at
default position.
Accessing PIP and POP Modes using OSD
You can also use the OSD menu to access the same PIP and POP mode functions. To access these modes
using OSD:
1. Press the MENU +/- keys on the remote or the front control panel.
2. Use the ADJ +/- keys to switch to “PIP/POP” Menu.
3. Make sure that the “Picture” OSD menu below is displayed.
4. Use the MENU +/- keys to move up and down to choose the sub-category you wish to change.
5. Use the ADJ +/- keys to actually change the setting.
PIP On/Off
Input Source Selection
PIP Window Position
1. Choose between FIXED or VARIABLE windows position.
2. If set to FIXED, the PIP window can be set in any one of the four
corners of the screen. Use H-LOCATION and V-LOCATION to
set the position of the window.
3. If set to VARIABLE, the PIP window can be variably set to any-
where on the screen using H-LOCATION and V-LOCATION.
PIP Window SWAP
1. By default, the OSD will always display DISABLE. To swap the
main and sub windows, use the ADJ +/- key to switch to
ENABLE. Once the swap is complete, the OSD will return to
display DISABLE.
POP On/Off
Input Source Selection
Screen Rate (Aspect Ratio Control)
1. When split screen picture is turned on, you can change the aspect
ratio for the image displayed.
2. Choose FULL to show a full screen image. The displayed image
may appear distorted because the display has to manipulate the
image so that it fits within the smaller window.
3. Choose 4:3 to show an image in native 4:3 aspect ratio within the
POP windows. Small black bars are added in order to maintain a
true 4:3 aspect ratio.
4. Choose 16:9 to show an image in wide-screen aspect ratio within
the POP windows. Small black bars are added in order to main-
tain a true 16:9 aspect ratio.
PIP Window SWAP
1. By default, the OSD will always display DISABLE. To swap the
main (left) and sub (right) windows, use the ADJ +/- key to
switch to ENABLE. Once the swap is complete, the OSD will
return to display DISABLE.