Filter
Top Products
Chapter 11 Packages
Media Server User’s Guide
265
11.15.1 Backup: Step 1
Use this screen to specify the job information and back up type.
Click Add Job in the Protect > Backup screen to open the following:
Figure 139 Protect > Backup: Step 1
Execute Job Now Select a backup job in the list and click this to run the backup job immediately.
Restore Archive Select a backup job in the list and click this to restore the file(s) included in that backup
job to the NSA.
This applies to Archive backups only. Refer to Section 11.15.8 on page 274 to see the
screens.
Abort Job Select a backup job in the list and click this to stop the process if the backup job is
currently active.
Activate Job Enable the selected backup job.
Inactivate Job Disable the selected backup job.
Status This shows the current state of the backup job.
• Waiting means the backup job is not active but is scheduled to run at some time.
• Running indicates that the NSA is currently doing the backup job. When the backup
job is running, you can also see a progress bar.
Job Name This identifies the backup job.
Job Description This is a short description of the backup job.
Backup Info This lists down the backup job details: type, source and target. Refer to Section 11.15.1
on page 265 and Section 11.15.2 on page 267.
Scheduler Info This shows the backup schedule, including the frequency, the time it was last run in
(and whether or not it succeeded), and when it is scheduled to run again. The times use
yyyy-mm-dd hh:mm:ss format.
Refer to Section 11.15.4 on page 271.
Table 79 Protect > Backup
LABEL DESCRIPTION