Command Reference Guide Frame Relay Sub-Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 894
frame-relay interface-dlci <dlci>
Use the frame-relay interface-dlci command to configure the Data Link Connection Identifier (DLCI) for
the Frame Relay sub-interface. This setting should match the DLCI supplied by your Frame Relay service
provider. Use the no form of this command to remove the configured DLCI.
Syntax Description
<dlci> Specifies numeric value supplied by your provider.
Default Values
By default, the DLCI is populated with the sub-interface identifier. For example, if configuring the virtual
Frame Relay sub-interface labeled fr 1.20, the default DLCI is 20.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following example configures a DLCI of 72 for this Frame Relay endpoint:
(config)#interface frame-relay 1.16
(config-fr 1.16)#frame-relay interface-dlci 72
