Command Reference Guide HDLC Command Set
61200510L1-35E Copyright © 2005 ADTRAN 926
HDLC COMMAND SET
To activate the HDLC mode, enter the interface hdcl command at the Global Configuration mode prompt.
For example:
>enable
#
configure terminal
(config)#interface hdlc 1
(config-hdlc 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname> on page 928
alias link<“text”> on page 931
bandwidth <value> on page 932
bridge-group <group#> on page 933
crypto map <mapname> on page 934
dial-backup commands on page 936
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password> on page 952
fair-queue <threshold> on page 954
hold-queue <queue size> out on page 955
ip commands begin on page 956
keepalive <seconds> on page 974
lldp receive on page 975
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive] on page 976
