66
XP662 MANUAL Helicopter
1. Press the SCROLL button until “FSM” appears on
the screen.
2. Set all controls to the desired Fail-Safe positions.
Next press the CBHANNEL and INCREASE
button simultaneously. A high-pitch beep sound
will confirm that the preset positions have been
entered and accepted.
SERVO PRESET MEMORY
CL WILL FLASH WHEN FAIL-
SAFE SERVO POSITIONS
ARE ENTERED.
CL
FSM
Press the CHANNEL and INCREASE
buttons simultaneously to store the
desired fail-safe presets/positions.
Press the SCROLL and INCREASE buttons
simultaneously to exit the function mode.
FAIL-SAFE/HOLD MEMORY IN S-PCM MODULATION (continued)
6.10
Setting Servo Fail-Safe Presets in S-PCM Modulation
Press the INCREASE or
DECREASE buttons to activate the
preset position function.
Press the CHANNEL
button to access
channels 1-6.
1. Press the SCROLL and INCREASE buttons
simultaneously and hold.
2. Turn on the transmitter to enter the system mode.
3. Press the SCROLL button until “FS1” appears on
the screen. The #1 on the screen refers to the
specific channel (1-6) to be adjusted.
4. Press the INCREASE or DECREASE button to
activate (turn on) the preset position function for
that channel.
5. Press the CHANNEL button to move to the next
channel(s) to be adjusted (2-6). Repeat Step 4 for
each channel to be activated.
Note: If Hold Position (HO) is selected for all six
channels, this Function/Screen will not be present.
Activating Servo Fail-Safe Presets by Channel (S-PCM)
CHAPTER 6: FUNCTIONS (SYSTEM MODE)
•
Helicopter
