ZENworks® ESM 3.5 Administrator’s Manual 104
Note:
VPN clients that generate virtual adapters (e.g., Cisco Systems VPN Client 4.0) will display the: "Policy
Has Been Updated" message, and may switch away from the current location temporarily. The Policy has
not been updated, the ZSC is simply comparing the virtual adapter to any adapter restrictions in the current
policy. It is recommended that when running VPN clients of this type that the Disconnect command
hyperlink NOT be used.
VPN Adapter Controls
This is essentially a "mini" Adapter policy specific to the VPN Enforcement.
If an adapter is checked (changing it to Enabled, Except), those adapters (Wireless being specific
to card type) are permitted connectivity to the VPN.
Adapters entered into the exception list(s) below, are denied connectivity to the VPN, while all
others of that type will be given connectivity.
If an adapter is left is un-checked (Disabled, Except), then ONLY the adapters entered into the
exception list will be permitted to connect to the VPN, all others will be denied connectivity.
This control can be used for adapters incompatible to the VPN, for example, or adapters not
supported by the IT department.
This rule will override the adapter policy set for the switch-to location.
