Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual 265
Chapter 8: Expansion Modules
Installing A GSM/GPRS Module
• Apply gentle downward pressure to securely seat the card in the connector.
Figure 8.5 Inserting A PCMCIA Card
• Align the mechanical stop and use the four screws provided to secure in place.
Tighten the screws to a torque of 2 lbs-in (2 kgf-cm), or until finger-tight.
• Slide the SW1401 switch to the right to turn power back on.
• Replace the end-cap.
Tighten the end-cap screws to a torque of 3 lbs-in (3kgf-
cm), and replace the
back plate and battery.
8.1.5 Installing A GSM/GPRS Module
Warning: The installation of this GSM/GPRS module must be performed
using the appropriate anti-static devices. If unavailable, discharge
static from your body by touching a grounded metallic object
before
opening any covers on the unit.
The GSM/GPRS module (model # RA3010) accommodates a GSM radio, a SIM
card (sold separately) and is equipped with a built-in antenna,
which also acts as a
mechanical stop for the CF card
. The module snaps onto the expansion connector on
your WORKABOUT PRO.
Important: Backup any data in RAM first, since it will be erased when the
unit is turned off.
• Remove the battery. If your unit is using AC power, disconnect it.
Insert the PCMCIA card as
shown here, with the label
facing you.
