Chapter 8: Expansion Modules
Installing A GSM/GPRS Module
266
Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual
• Remove the stylus from the end-cap, and then remove the end-cap at the top
of the WORKABOUT PRO.
• Slide the SW1401 switch to the left to shut off internal battery power.
Important: In order for the WORKABOUT PRO to access the GSM network,
ensure that you slide the SIM (Subscriber Identity Module) card
into the GSM/GPRS module before installing that unit in the
WORKABOUT PRO.
With the power shut down, you can install the GSM/GPRS module and the antenna.
• Slide the SIM card into the GSM/GPRS module as shown in Figure 8.6,
with the card oriented printed side up and its notch on the right side.
• Align the GSM/GPRS connector with the expansion connector on the
WORKABOUT PRO. Apply slight pressure to snap the module into place
on the hand-held.
• Settle the SIM Card stopper plate into place with its metal tab inserted into
the SIM Card stopper plate slot on the GSM/GPRS module (for tab and slot
locations see Figure 8.6). Ensure that the scanner flex cable lies on top of
the plate.
• Use the four screws provided to secure the module and SIM Card stopper
plate in place. Tighten the screws to a torque of 2 lbs-in (2 kgf-cm) or until
finger tight
Figure 8.6 Inserting The SIM Into The GSM/GPRS Module
SIM Card Stopper Plate
Tab
SIM Card
Bracket
GSM/GPRS
Radio
SIM Card
Stopper Plate
Slot
SIM Card
GSM/GPRS Module with SIM Card installed
