Filter
Top Products
En
ENGLISH
11
SOUND
AUDIO ADJUSTMENTS
Q SURROUND
MODE
CURSOR
ENTER
VOLUME
VOLN/M
Q SURROUND
VOLUME
Turn VOLUME on the main unit or press VOL N/M on the
remote control.
The volume level is displayed as a number from 0 to 49 followed
by MAX.
If the power is turned off while the volume level is set to 21 or
more, it will automatically be set to 20 when the power is turned
on the next time.
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency sound.
1 Press MODE once so that "T-BASS" is displayed.
2 Within 6 seconds, move CURSOR i or k.
You can select one of the three levels or the off position.
The T-BASS level does not change cyclically.
(OFF)
NOTE
Low frequency sound may be distorted when the T-BASS system
is used for a disc in which low frequency sound is originally
emphasized. In this case, cancel the T-BASS system.
PREPARATIONSSOUND
ENHANCING THE TREBLE SOUND
The BBE system enhances the clarity of high-frequency sound.
1 Press MODE repeatedly until "BBE" is displayed.
Alternatively, press MODE once and move CURSOR j or l
until "BBE" is selected.
2 Within 6 seconds, move CURSOR i or k.
You can select one of the three levels or the off position.
The BBE level does not change cyclically.
(OFF)
Q SURROUND SYSTEM
The Q surround system built into this unit uses only two speakers
at the left and right to create an atmosphere that sounds as if you
are surrounded by two front speakers and two rear speakers.
Press Q SURROUND to turn on or off the Q surround system.
Example: When the Q surround system is turned on
NOTE
• The Q SURROUND system does not work in monaural mode.
• At higher volumes, turning Q SURROUND on may cause sound
distortion. In this case, turn the volume down, or turn off the Q
SURROUND system.
GRAPHIC EQUALIZER
This unit provides the following three different equalization curves.
ROCK: Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
JAZZ: Accented lower frequencies for jazz-type music
1 Press MODE repeatedly until "EQ OFF" or the currently
selected mode is displayed.
Alternatively, press MODE once and move CURSOR j or l
until "EQ OFF" or the currently selected mode is displayed.
2 Within 6 seconds, move CURSOR i or k to select the
desired equalization curve.
Example: When "ROCK" is selected
To cancel the equalization mode
Repeat the above and select "EQ OFF".