Filter
Top Products
32
ENGLISH
RADIO
RECEPTION
MANUAL TUNING
r,t
MONO TUNER
BAND
SHIFT
POWER
r,t
TUNER/
BAND
1
Press TUNER/BAND repeatedly to select the
desired band.
FM AM
When TUNER/BAND is pressed while the power is off, the
power is turned on directly.
To select a band with the remote control
Press BAND while pressing SHIFT.
NOTE
• When you switch to the tuner function from the DVD/CD
function while "READING" flashes on the display, it may take
up to 10 seconds before the sound actually switches to the
tuner.
• When you switch to the tuner function, the monitor is
automatically turned off.
2
Press r or t to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, "TUNE" is displayed for 2 seconds.
During FM stereo reception, 1 is displayed.
1
To search for a station quickly (Auto Search)
Keep r or t pressed until the frequency starts to change
rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press r or t.
• The Auto Search may not stop at stations with very weak signals.
When an FM stereo broadcast contains noise
Press MONO TUNER while pressing SHIFT on the remote control
so that "MONO" appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, repeat the above so that "MONO"
disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If you
use this unit in an area where the frequency allocation system is 9
kHz/step, change the tuning interval.
Press POWER while pressing TUNER/BAND.
To reset the interval, repeat this procedure.
NOTE
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.