Filter
Top Products
For example, to assign Astra 2S and Hotbird for your satellite
pair, and to track Astra 2S, you would enter the following data:
SATINSTALL,ASTRA2S,HOTBIRD<cr>
@L,A<cr>
ZAP<cr>
2.5.2 Programming User-defined Satellites
The TracVision C3 satellite library has two open slots that you
may use to program two user-defined satellites in case you want
to install/watch a satellite that is not in the KVH predefined list.
To configure a user satellite, the system must first be in Idle
Mode (by typing
HALT) and then information about the satellite
must be provided, including:
• Satellite name
• Satellite position (longitude)
•Transponder information for each of the following
polarizations/frequencies:
- vertical high & vertical low
- horizontal high & horizontal low
or
- right
- left
•Transponder information includes:
-frequency
- symbol rate
- FEC code, and
- network ID (in hexidecimal format)
• Decoder type
This information can be obtained from your satellite service
provider or from sites on the Internet, such as www.satcodx.com.
2-19
Installation
54-0159 Rev. G
For your reference, the satellite
configuration information for the
predefined satellites is available on
our web site at www.kvh.com/
footprint/index.html.