Filter
Top Products
Chapter 4. Hotkey Mode
33
Auto Scanning
Auto Scan mode switches among all the ports that are accessible to the current
operator at regular intervals (see Scan Mode, page 26, for information
regarding accessible ports). This function is convenient for automatically
monitoring the activity of the computers on the installation.
Setting the Scan Interval
The amount of time Auto Scan mode focuses on each port is set with the Scan
Timer (see Set Scan on page 26). You can change the scan interval before
activating Auto Scan mode, if you wish, with the following hotkey
combination:
1. Invoke Hotkey mode (see page 31).
2. Key in [T] [n]
Where [T] is the letter T, and [n] is a number from 0–240 that represents
the number of seconds for the dwell time.
The letter T and the numbers display on the command line as you key
them in. If you make a mistake, use [Backspace] to erase the wrong
number.
3. Press [Enter]
After you press [Enter], you automatically exit Hotkey mode, and are
ready to invoke Auto Scanning.