Filter
Top Products
S-Video and Composite Configuration
The S-video and composite outputs only output
interlaced signals. There are different standards for
these signals in different parts of the world. The
switch marked “0%” and “7.5%” controls whether
the black level is changed by adding setup to the
NTSC signals. PAL signals are unaffected by the
setting of this switch.
Setup is normally only used in North America. If
you live in the USA, Canada, or Mexico, setting
this switch to “7.5%” will produce a signal that
matches your other video source components.
Residents of other countries should set this switch
to “0%”.
Please refer to the chapter “Optimization and
Customization” for additional information on
playing DVDs from other countries.
Setup Navigator
The Ayre DX-7 has a wide variety of system settings
that may be configured via the On-Screen Setup
Menus (page 49). To simplify the initial setup of
your player, the Setup Navigator allows you to
configure the basic settings via a series of on-screen
questions.
11
0255-
YCbCr
Rsrv B
Rsrv D
7.5%
Intrlc
YPbPr
SoG
16 2 35-
RGB
Rsrv A
Rsrv C
0%
Prog
RGB
HVSync