Filter
Top Products
15-15
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-29225-01
Chapter 15 Configuring QoS
QoS Configuration Examples
Troubleshooting Admission Control
You can use two CLI commands to display information to help you troubleshoot admission control
problems:
• To display current admission control settings on radio 0, enter the following command:
# show dot11 cac int dot11Radio 0
• To display current admission control settings on radio 1, enter the following command:
# show dot11 cac int dot11Radio 1
• To display information about admitted streams with admission control and MT, enter the following
command:
# show dot11 traffic-streams
QoS Configuration Examples
These sections describe two common uses for QoS:
• Giving Priority to Voice Traffic, page 15-15
• Giving Priority to Video Traffic, page 15-16
Giving Priority to Voice Traffic
This section demonstrates how you can apply a QoS policy to your wireless networks’ voice VLAN to
give priority to wireless phone traffic.
In this example, the network administrator creates a policy named voice_policy that applies voice class
of service to traffic from Spectralink phones (protocol 119 packets). The user applies the voice_policy
to the incoming and outgoing radio ports and to the outgoing Ethernet port. Figure 15-5 shows the
administrator’s QoS Policies page.