Cisco Systems 15.2(2)JB Universal Remote User Manual


 
18-10
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-29225-01
Chapter 18 Configuring SNMP
Configuring SNMP
To remove the specified host from receiving traps, use the no snmp-server host host global
configuration command. To disable a specific trap type, use the no snmp-server enable traps
notification-types global configuration command.
Setting the Agent Contact and Location Information
Beginning in privileged EXEC mode, follow these steps to set the system contact and location of the
SNMP agent so that these descriptions can be accessed through the configuration file:
Using the snmp-server view Command
In global configuration mode, use the snmp-server view command to access Standard IEEE 802.11 MIB
objects through IEEE view and the dot11 read-write community string.
This example shows how to enable IEEE view and dot11 read-write community string:
AP(config)# snmp-server view ieee ieee802dot11 included
AP(config)# snmp-server community dot11 view ieee RW
SNMP Examples
This example shows how to enable SNMPv1, SNMPv2C, and SNMPv3. The configuration permits any
SNMP manager to access all objects with read-only permissions using the community string public. This
configuration does not cause the access point to send any traps.
AP(config)# snmp-server community public
Step 5
show running-config Verify your entries.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
snmp-server contact text Set the system contact string.
For example:
snmp-server contact Dial System Operator at beeper 21555.
Step 3
snmp-server location text Set the system location string.
For example:
snmp-server location Building 3/Room 222
Step 4
end Return to privileged EXEC mode.
Step 5
show running-config Verify your entries.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.