Filter
Top Products
C-4
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-29225-01
Appendix C Error and Event Messages
Software Auto Upgrade Messages
Error Message AUTO-INSTALL-4-IP_ADDRESS_DHCP: “The radio is operating in automatic
install mode and has set ip address dhcp.”
Explanation
The radio is operating in automatic install mode and is configured to receive an IP
address through DHCP.
Recommended Action Use the station-role configuration interface command to configure the radio
for a role other than install mode.
Error Message AUTO-INSTALL-6_STATUS: “%s” %s. RSSI=-%d dBm.: “The radio is operating
in install mode.”
Explanation
The radio is operating in automatic install mode.
Recommended Action Use the station-role configuration interface command to configure the radio
for a role other than install mode.
Error Message AVR_IMAGE_UPDATE-7-UPDATE_COMPLETE: “The AVR "$d" firmware was
successfully updated.”
Explanation
The access point AVR firmware was successfully updated.
Recommended Action None.
Error Message AVR_IMAGE_UPDATE-2-UPDATE_FAILURE: “The AVR "$d" firmware is not
current. Update error: "$s".”
Explanation
The AVR firmware is not current and the update failed
Recommended Action Copy the error message and report it to your technical support representative.
Error Message AVR_IMAGE_UPDATE-4-UPDATE_SKIPPED: “AVR "$d" update processing was
skipped:"$s".”
Explanation
AVR update processing was skipped due to an error.
Recommended Action None.
Error Message AVR_IMAGE_UPDATE-4-UPDATE_START: “The system is updating the AVR "$d"
firmware. Please wait . . . “
Explanation
The system is updating the AVR firmware.
Recommended Action None.