Filter
Top Products
ANTENNA IN / OUT - For Antenna or Cable TV OPTICAL DIGITAL AUDIO OUTPUT - Use to
connection. Passthrough connection to TV does not connect to a receiver or other device with 5.1 channel
transfer the output signal from the DVD Recorder. decoders. This output is the coded digital signal.
*Some units do not have a Passthrough connector. In this
POWER CORD SOCKET - Plug the matching end
case, use the included splitter (See page 13).
of the power cord into the unit before connecting the
VIDEO INPUT 1 - Composite Video input for other end to the wall socket.
recording. To select this input, use the SOURCE button
MAIN POWER SWITCH - The main power
and choose VIDEO IN 1.
switch must be set to ON for the unit to function. Make
S-VIDEO INPUT 1 - S-VIDEO input for recording. To
sure all cable connections are complete before
select this input, use the SOURCE button and choose S-
switching the main power switch to ON. When the
VIDEO IN 1.
main power switch is turned ON, the unit will enter
COMPONENT/PROGRESSIVE SCAN VIDEO
Standby Mode, where it may be turned on with the
OUTPUT - Use this output with TVs supporting
remote control or the front power switch.
Component Video or Progressive Scan input for best
STEREO AUDIO INPUTS - Use with S-VIDEO IN
video quality. Select this output in the DVD Recorder’s
1 or VIDEO IN 1 for recording.
SETUP MENU.
S-VIDEO OUTPUT - Connect to TVs with S-VIDEO
STEREO AUDIO OUTPUT - Connect to TVs or other
in for better picture quality than standard composite
audio equipment supporting Stereo Audio in.
video.
COAXIAL DIGITAL AUDIO OUTPUT - Use a
COMPOSITE VIDEO OUTPUT - Standard Video
special coaxial digital audio connector to send the raw
Output supported by most TVs.
coded digital signal to devices supporting digital
decoding.
1
8 9
1
2
3
4
5
6
7
8
9
10
11
10
FUNCTIONAL OVERVIEW
Back Panel
ON
OFF
I
O
AC IN
~100-230V
2
4
3
6
5
7
121110
12