Filter
Top Products
DISPLAY
AUDIO SUBTITLE MUTE
DIGEST
HIDE
BOOKMARK
ON
OFF
I
O
AC IN
~100-230V
CONNECTIONS
S-Video
Input Jack
Component Video
Input Jacks
Y Pb Pr
S-Video
This is a higher quality connection than standard composite video, and requires a special S-Video cable not included. The S-Video
connector is distinguishable by its 4 pins, as shown below. If your TV has an S-Video input, it’s recommended that you use this type
of connection for better picture quality.
Component Video
The highest quality video connection, component video requires separate cables for the Y, Pb, Pr signals. To use the progressive scan
option on this unit, you’ll need to use the component video output. Using the component video output requires these steps:
First, use the supplied A/V cable to connect to the
composite video input on your TV. Select this input.
2
Enter the player’s Setup Menu by pressing SETUP on the
remote control.
1
3
Change the VIDEO OUTPUT setting under VIDEO SETUP
to COMPONENT. If you are using a Progressive Scan TV,
change the OUTPUT FORMAT to PROGRESSIVE.
Press SETUP to exit the SETUP MENU and connect the
Component Video cables. Select the correct video input
on your TV.
4
S-Video Cable
First, obtain a special S-Video cable. Connect the S-
Video output from the unit to the corresponding input
on your TV.
2
Turn on the unit and select the DVD mode.
1
3
On your TV, select the S-Video input. This is normally
done by selecting “Video 2” or “AV2” with the remote
control. On some TVs, this is done by selecting a
particular channel.
4
You should now see the DVD player’s splash screen on
the TV.
TV with
Component
Video Input /
Progressive Scan
capability.
VIDEO
INPUT
Y Pb Pr
TV with
S-Video Input
S
VIDEO
INPUT
12
SETUP
Language
Video Setup
Audio Setup
System Setup
Disc Media
Record Mode
Timer Record
VIDEO SETUP
Aspect Ratio
Video Output
Output Format
VIDEO OUTPUT
Composite
S-Video
Component
SETUP
Language
Video Setup
Audio Setup
System Setup
Disc Media
Record Mode
Timer Record
Component
Video Cable
!
If you inadvertently switch the OUTPUT FORMAT setting to
PROGRESSIVE while using a standard TV not capable of P-
SCAN, you will loose video. If this happens, reset the recorder
to its default video settings by following these steps:
1) Power the unit Off, then On again with the main power
switch on the back.
2) Eject the disc and close the disc tray.
3) Press and hold the STOP button on the front panel for 3 full
seconds.
Resetting the video output