Filter
Top Products
15
ENGLISH
✽ Set the “AUDIO SETUP” default setting as shown below. (See pages 38 ~ 41.)
• “DIGITAL OUT” → “PCM”
“LPCM (44.1kHz/48kHz)” → “ON”
Playing DVDs with incorrect settings may result noise that could damage your ears or the speakers.
(5) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)
8 9
B
Optical fiber cable (commercially available)
75Ω/ohms pin-plug cable (commercially available)
DVD-3910
(6) Connecting to a Stereo Component
DVD-3910
Stereo component
NOTE:
• When connecting to a 2-channel audio stereo device using the 5.1ch AUDIO OUT, set “AUDIO CHANNEL” under “AUDIO
SETUP” on the “SETUP” to “2CH (SRS OFF)” or “2CH (SRS ON)” (see page 38.). For multi-channel sources, the signals are
down-mixed into two channels (analog).
(Only the front left and right channels are output for sources for which down-mixing is prohibited.)
Digital audio
input connector
(COAXIAL)
Digital audio
input connector
(OPTICAL)
NOTE:
• Digital audio signals cannot be output when playing Super Audio CDs. Use analog connections to record Super Audio CDs.
(or)