Dynex DX-19E310NA15 Flat Panel Television User Manual


 
18
Dynex 19" LED TVDX-19E310NA15
www.dynexproducts.com
Connecting an antenna or cable TV (no box)
1 Make sure that your TV’s AC power adapter is unplugged and all connected equipment is turned off.
2 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the back of your TV and to the antenna or cable TV
wall jack.
3 Plug your TV’s AC power adapter into a power outlet, then turn on your TV.
4 Press INPUT to open the INPUT SOURCE list.
5 Press
or
to highlight TV, then press ENTER.
6 If you cannot tune to channels you know exist, scan for channels. See “Automatically scanning for channels” on page 54.
Notes
Use a coaxial cable to eliminate interference and noise from
radio waves.
Do not bundle the coaxial cable with the AC power adapter or
other cables.
If the antenna is not installed correctly, contact qualified service
personnel to correct the problem.
If the signal level for a channel is weak, the picture may be
distorted. Adjust the antenna or use a highly directional
outdoor or set-top antenna with a built-in amplifier.
If the picture quality is good on some channels and poor on
others, the problem may be caused by a poor or weak signal
from the broadcaster or cable TV provider.
If you connect to cable or satellite TV without a set-top box and
experience poor picture quality, you may need to install a
set-top box to improve signal reception and picture quality.
Contact your cable or satellite TV provider about upgrading to
a set-top box.
Many high-definition (HD) channels upscale
standard-definition (SD) content. The picture displayed on your
TV is still displayed as SD, thus the picture quality will not be as
clear or crisp as it would be if the content was originally
recorded in HD.
Coaxial cable
Antenna or cable TV
(no box)
Back of TV
Coaxial cable
connector
ANT/CABLE IN
jack
On your TV