Filter
Top Products
42 Making Detailed Adjustments
■ Progressive
Converts interlaced to progressive signals. The projector uses 3D DigiScan
™
HD
Circuitry Processing for video-sourced images.
Leave the setting on
Film/Auto for viewing movies on a player that produces interlaced
output. Select
Video for watching videos captured with a video camera. Set to Off when
viewing images with a large amount of movement.
Note: This setting can be used only when viewing a composite video signal, or 480i or 576i, or
1080i signals input through the Component, HDMI 1, or HDMI 2 ports (see page 81).
■ Motion Detection
This setting specifies how signals are converted to progressive signals. Select a lower
setting for slow-moving or still images (
S) or select a higher number for video images
(
M).
Note: This setting can be used only when viewing a composite video signal, or 480i or 576i, or
1080i signals input through the Component, HDMI 1, or HDMI 2 ports (see page 81).
■ Noise Reduction
Note: This setting may not be available when the Color Mode is set to Auto (see page 32) or
with a signal input through the PC port.
This setting reduces flickering of analog images. You can select from 3 levels of noise
reduction.
■ 2-2 Pull-down
Note: This setting can be used only when viewing a 1080p/24Hz signal input through the
Component, HDMI 1, or HDMI 2 ports (see page 81). This setting cannot be used when the
Color Mode is set to Auto (see page 32) or with a signal input through the PC port.
This setting allows you to select whether images are projected with 2-2 Pull-down
detection or 2-3 Pull-down detection. Select
On for 2-2 Pull-down detection.
Signal > Progressive
Signal > Motion Detection
Signal > Advanced > Noise Reduction
Signal > Advanced > 2-2 Pull-down
pl3010_3010e_UG.book Page 42 Wednesday, September 7, 2011 6:28 PM