Filter
Top Products
Problem Solving 75
Solving Remote Control Problems
The projector doesn’t respond to remote control commands.
■ Make sure you’re within about 32 feet (10 m) of the projector, and the remote control is
aimed at the projector’s front or back sensor within the ranges shown below.
■ You may need to replace the remote control batteries (see page 21). Press the
illumination button and check if the buttons glow. If they don’t, replace the batteries.
■ Dim the room lights and turn off any fluorescent lights. Make sure the projector is not in
direct sunlight.
■ Turn off nearby equipment that emits infrared energy, such as a radiant room heater.
■ Make sure there are no objects between the remote control and the IR receiver.
Solving WirelessHD Problems
The projector cannot display images from the WirelessHD Transmitter.
■ Open the WirelessHD reception monitor and check the strength of the WirelessHD
signal (see page 47). If the signal is weak, you may need to move the transmitter closer to
the projector or remove any large objects located between the transmitter and the
projector.
32 ft (10 m)
32 ft (10 m)
32 ft (10 m)32 ft (10 m)
pl3010_3010e_UG.book Page 75 Wednesday, September 7, 2011 6:28 PM