Filter
Top Products
52 Making Detailed Adjustments
3. Do one of the following:
■ Select Reset Lamp Hours to clear the lamp usage timer and reset it to zero.
You should reset the lamp timer only when you install a new projector lamp. See
page 67 for more information.
■ Select Reset Memory to clear all memory settings.
■ Select Reset All to return all projector settings to their original defaults (except Input
Signal, User Button, Language, and Lamp Hours).
Customizing Projector Features
Use the settings in this section to adjust the image size and position, suppress on-screen text,
and select basic setup options.
Image Sizing
Before adjusting any of these settings, make sure you have already selected an appropriate
aspect ratio for the type of picture you’re viewing (see page 27).
■ Overscan
For component and HDMI video formats, this setting lets you see the edges of the image
that are not normally visible in the picture (see page 81). If you see interference when you
set
Overscan to Off, try adjusting the Position as described below.
Note: The Auto setting is only available when the input source is HDMI1, HDMI2, or
WirelessHD.
■ Position
Note: This setting cannot be used with a signal input through the HDMI 1 or HMDI 2 port or
the WirelessHD connection (PowerLite Home Cinema 3010e only).
Use the arrow buttons to fine-tune the position of the image on the screen.
Signal > Advanced > Overscan
Signal > Position
pl3010_3010e_UG.book Page 52 Wednesday, September 7, 2011 6:28 PM