Filter
Top Products
16
ENGLISH
To operate projector power ON
Numbers 1 - 9 correspond to the instruction numbers below.
Important:
• A darkened image may be seen right after pressing
the POWER button due to warming up of this pro-
jector. When warming up, no other commands can
be accepted.
• When the lamp indicator is blinking red, the ser-
vice life of the lamp is about to end. Replace the
lamp. See pages 40 and 44.
• The picture might not be of optimum performance
in extreme hot or cold conditions. (The projector is
not malfunctioning.)
4. Select the desired external input source by using
the RGB or VIDEO button.
• The projector automatically selects the appropriate
signal system. The selected signal system is dis-
played on the SIGNAL menu.
• When selecting the RGB1 or RGB2 input, the im-
age may be flickered. Press the FINE buttons to
adjust the image.
• Press CARD button to see the PC CARD images.
(You cannot select it when CARD 1 or CARD 2 indi-
cator is not lighting up.)
1. Put the projector into standby mode by pressing the
main power switch. The POWER indicator lights up
red.
2. Turn on the equipment connected to the projector.
3. Turn the projector on by pressing the POWER but-
ton.
The light source lamp starts warming up, eventu-
ally turn on. In cases where light source lamp does
not come on, wait for one minute before switching
power on again.
• If power to the main unit is turned off within
two minutes of turning off the light source
lamp, power will not be introduced to the lamp
for one minute the next time the main unit
power switch is turned on. When this happens,
the indicator lamp will blink for one minute.
RGB1 IN
RGB2 IN
RGB OUT
LINE
-OUT
AUDIO
AUDIO
MAIN
VIDEO
AC IN
L
R
INPUT1 INPUT2
RS-232C 1 RS-232C 2
OI
S-VIDEO
2, 9
Left side
AUTO position
button
LAMP
RGB MENU
AUTO
POSITION
FINE
VIDEO
CARD
FOCUS
/ZOOM
ENTER
TEMP CARD 1
CARD 2
4 4 563, 7, 8
condition
indicator
LAMP
POWER
stand-by
-
red
when light source lamp is on
green
green
when light source lamp does not light up
red
-