Filter
Top Products
19
ENGLISH
Q SIGNAL
AUTO .................. Use to select AUTO, USER 1 or USER 2.
HORIZ. POSITION....
Use to adjust the horizontal position of the image.
VERT. POSITION .....
Use to adjust the vertical position of the image.
FINE SYNC. ....... Use to synchronize the projector with PC input signals so that the image is not blurred.
TRACKING ......... Use to avoid image noise such as wide stripes.
RGB/Y, C
B
, C
R
.........
The unit adjusts itself automatically when connected to either DVD players with a
component video output terminal (Y, CB, CR or Y, PB, PR) or equipment with HDTV signal
output capabilities. In cases where the unit is connected to equipment that include an RGB
output terminal and which output HDTV signals, adjust the unit to RGB mode.
Qa SIGNAL - USER (Normally, there is no need for adjustments.)
CLAMP POSITION/
CLAMP WIDTH .........
If you use a PC video card or something similar, the lighter colors of the projected image
may become blurred. In this case, adjust CLAMP POSITION or CLAMP WIDTH.
HORIZ. PIXELS ....
Use to adjust the height of the image. The image size grows higher as the number
increases. (Adjust to the horizontal pixels of inputting signal for normal setting.)
VERT. LINES ..... Use to adjust the width of the image. The image size grows wider as the number increases.
(Adjust to the vertical lines of inputting signal for normal setting.)
PLL ...................... Use to adjust the image which upper right side is awry. Select AUTO for normal setting.
VERT. SYNC. ..... Use to adjust the image when its motion does not run naturally. Select AUTO for normal
setting.
HOLD .................. Adjusts the image which upper right side is awry.
W PICTURE
CONTRAST ........ Adjusts the picture contrast. The contrast becomes higher as the number increases.
BRIGHTNESS .... Adjusts image brightness. The image becomes brighter as the number increases.
TINT .................... Adjusts the color balance in the image. The color balance of the image shifts green as the
number increases and shifts to purple as the number decreases (only when NTSC or 4.43
NTSC is selected).
COLOR ................ Adjusts the color intensity of the image(only when NTSC, PAL, SECAM or 4.43 NTSC is
selected).
GAMMA
CORRECTION ... Corrects the proportion of the brightness of input signals to that of output signals. Also
corrects the contrast of projected images.
Q W E R
T
Y U I
MENU
OPTION Ver.INSTALLATIONAUDIO
PC CARD
AUTO PLAY
PinP/
EXPAND
PICTURESIGNAL
or or or or
or
or or or
AUTO
AUTO
USER1
USER2
SXGA70a
0 0 0
RGB
Y,C
B,CR
USER
HORIZ.
POSITION
VERT.
POSITION
FINE SYNC. TRACKING
RGB/Y,CB,CR
0
MEMORIZE
DELETE
RESET
OPTION Ver.INSTALLATIONAUDIO
PC CARD
AUTO PLAY
PinP/
EXPAND
PICTURESIGNAL
Qa
ENTER
/STILL
33 33
33
3333 3333
AUTO AUTO
ON
OFF
AUTO
BEGIN
CLAMP
POSITION
CLAMP
WIDTH
HORIZ.
PIXELS
VERT.
LINES
VERT.
SYNC.
SIGNAL - USER
PLL HOLD
33
END
ON
OFF
FAST
NORMAL
SLOW
CONTRAST BRIGHTNESS TINT COLOR
GAMNMA
CORRECTION
0 000
USERUSERUSER
OPTION Ver.INSTALLATIONAUDIO
PC CARD
AUTO PLAY
PinP/
EXPAND
PICTURESIGNAL