Filter
Top Products
17
ENGLISH
AUTO POSITION button
When the source is selected to RGB1 or RGB2 and
the image is not in the right place, set to display as
blightest signal as possible, then press the AUTO
POSITION button. If the image is still not in the
right place.
• Set screen to the brightest display possible (e.g.,
full-screen display of the “Trash” window) before
deploying the automatic adjustment function.
• If the screen saver is running, turn off the screen
saver before using the automatic adjustment
button.
5. Press the FOCUS/ZOOM button to FOCUS. “FO-
CUS” will appear on the display.
6. Adjust with the ª or º buttons on the control
panel (or { or } buttons on the remote control) to
get a fine picture.
• Focus and zoom adjustment by using the buttons on
the control panel or the remote control is possible in
the normal picture mode only. In PinP, EXPAND or
cursor operation mode, the adjustment is impossible.
The volume from the speaker
Press the VOLUME buttons on the remote control to
change the volume from the speaker. You can also
change it by selecting the volume in AUDIO menu.
When setting “ON” for MUTE in AUDIO menu, you
can stop the sound momentary.
• The volume button does not work when MENU se-
lecting bar or MENU is displayed.
Turning off the projector
7. Press the POWER button.
The message “POWER OFF? YES : PRESS AGAIN”
appears on the screen.
• To exit from this mode, press any button except
POWER button.
8. Press the POWER button again.
The light source lamp will be turned off.
By pressing the POWER button again, shuts off the
light source lamp, but the exhaust fan continues to
operate for 120 seconds to cool down the light source
lamp and LCD panels. In this time, the lamp indica-
tor will be turned off from flashing.
9. Turn off the main power switch. When turning off
the main switch, the POWER indicator turns off.
• In cases where the main power switch is acciden-
tally turned off when either the intake/exhaust
fan or the power source lamp is in operation, allow
the unit to cool down for 10 minutes with the
power turned off. Repeat step 3 when turning on
the power source lamp. If the lamp does not turn
on immediately, repeat this step two or three
times. Replace the lamp if it should still fail to
turn on.
Caution:
• When you have finished using this equipment, wait
120 seconds for the exhaust fans to stop. Then turn
off the main switch and unplug the power cable from
the wall outlet, for safety purposes.
• After the lamp is turned off, the lamp cannot be
switched on again for 60 seconds as a precaution-
ary measure. It will take another 60 seconds before
the lamp indicator goes off. If you wish to turn on
the projector again, wait until the indicator is off
then press the POWER button.
• The exhaust fans faster automatically when the tem-
perature around the projector becomes high.
• When the temperature around the projector becomes
much higher, the sign of “TEMP!!” blinks red on the
screen. If the temperature stays in high, the lamp will
be shut off automatically .
The projector automatically shuts off when the
lamp is used up in about 1,300 hours and not used
until lamp replacement.