Filter
Top Products
Special Applications, cont’d
MLC 52 Series MediaLink Controllers • Special Applications4-6
Projector remote control type B (application 1)
This remote control has only two input buttons — one for the RGB inputs and one
for the S-video and composite video inputs. Each of these buttons contains one
command that causes the projector to toggle between inputs.
• Program the command from the projector remote control’s Computer or RGB
button onto the MLC’s PC button.
• Program the command that is on the projector remote control’s Video button
onto the MLC’s Video button.
The MLC now has one command each on its PC and Video buttons. You must still
repeatedly press an input button to switch between selected sources; however, the
button actually contains only one command (a projector input toggle command).
MLC 52
PROJECTOR
ON
PC
VIDEO
OFF
VOL
VOL
Command #1: Computer
Projector Remote Control Type B
Command #2: Video
SIZE
ENTERMENU
CENTER
CONT/
BRT
COL/
TINT
ASPECT
RATIO
VIDEO
MUTE
AUDIO
MUTE
A/V
MUTE
SHARP
PHASE
VIDEO
COMPUTER
Programming MLC 52 input selection buttons from a projector remote
control type B
If you are using an MLC 52 IR VC or an MLC 52 RS VC with a type B remote
control, program the buttons using the following scheme:
Projector Remote Control Type
B
SIZE
ENTERMENU
CENTER
CONT/
BRT
COL/
TINT
ASPECT
RATIO
VIDEO
MUTE
AUDIO
MUTE
A/V
MUTE
SHARP
PHASE
VIDEO
COMPUTER
MLC 52
DISPLAY
ON
PC
OFF
VIDEO
VOLUME
Command #1: Computer
Command #1: Video. The
button should be placed in input
switch mode.
Leave blank and do not
program. The button should
be in single switch mode.
Leave blank and do not
program. The button should
be in single switch mode.
Programming MLC 52 IR VC and MLC 52 RS VC with a projector remote
control type B