Filter
Top Products
5-15MLC 52 Series MediaLink Controllers • Serial Communication
Assign Commands To Buttons window with PC button selected
To add a command to a button,
a. Click on the screen button that you want to program. A yellow box
appears around it, and its name is displayed in the Selected Button
field. In the illustration above, the button labeled “PC” was selected.
b. In the Select Driver Command field, click on the command function
you want the selected button to execute. In the illustration, RGB1 was
selected.
c. Click Add Command. The selected
command appears in the next available slot
in the Assigned Driver Commands field,
replacing <EMPTY>. See the example at
right.
d. If you want to add another command to the
same button, repeat steps 5b and 5c. You
can assign up to four commands to a
button.
e. If you want to assign commands to another
button, repeat steps 5a through 5d for each
button that you want to program.
If you do not want to add a command to a button at this time, click Skip to
go to the next screen.
To remove a command from a button,
a. Click on the button from which you want to remove the command.
b. In the Assigned Driver Commands field, click on the command
function that you want to remove.
c. Click Remove Command. The command name is replaced by
<EMPTY> in the Assigned Driver Commands field.