Filter
Top Products
4-15MLC 52 Series MediaLink Controllers • Special Applications
Issuing input selection commands learned from remote control type B
The MLC now has two commands each on the PC and Video buttons. When you
press an MLC input button repeatedly, the following commands are issued:
Using the PC button (RGB):
• First press (memory block #1): The MLC 52 issues command “A” for RGB
input selection.
• Second press (memory block #2): The MLC 52 issues command “B” for
RGB input selection.
Using the VIDEO button (S-video or composite video):
• First press (memory block #1): The MLC 52 issues command “A” for
composite video input selection.
• Second press (memory block #2): The MLC 52 issues command “B” for
S-video input selection.
Programming VC models — Projector remote control type B
If you are using a type B remote control with an MLC 52 IR VC or an
MLC 52 RS VC, configure the buttons according to the diagram below.
SIZE
ENTERMENU
CENTER
CONT/
BRT
COL/
TINT
ASPECT
RATIO
VIDEO
MUTE
AUDIO
MUTE
A/V
MUTE
SHARP
PHASE
VIDEO
COMPUTER
MLC 52
DISPLAY
ON
PC
OFF
DVD
VCR
VOLUME
Command #1: Computer IR Command “A”
Command #2: Computer IR Command “B”
Leave blank and do not program. The
button should be in single switch mode.
Leave blank and do not program. The
button should be in single switch mode.
Command #1: Video 1 IR Command “A”
Command #2: Video 2 IR Command “B”
Label the button accordingly and place it in
input switch mode.
Projector Remote Type B
Programming an MLC 52 VC model with a projector remote control
type B