Filter
Top Products
2-10 IC697VAL348 8-Channel, 16-bit Digital-to-Analog Converter Board User’s Manual GFK-2059
– December 2001
2
Connector Descriptions
Two 96-pin DIN type connectors, P1 and P2, connect the DAC board to the VMEbus backplane.
The primary connector, P1, contains the address data and control lines and all additional signals
necessary to control data transfer and other bus functions. See Figure 2-4 on page 2-11 and Table
2-2 on page 2-12 for the P2 connector signal assignments.
The P3 connector is a Panduit 32-pin male connector type, number 120-332-033A. The matching
Panduit connector for the input cable is a female connector type, number 120-332-435E. This
connector handles the 16 analog outputs, each with an associated analog ground wire. See Figure 2-
5 on page 2-13 and Table 2-3 on page 2-14 for P3 connector assignment.