Filter
Top Products
4
Dual-Deck VCR User’s Guide
REMOTE CONTROL SETUP
Follow these steps to program the remote
control to operate your television*.
1 TURN ON TELEVISION
Press POWER on your television.
2 ENTER CODE
Press and hold the TV key on the VCR remote
control while entering the 2-digit code for your
brand of television with the 0-9 keys (see table
below). If there is more than one code for your
brand of television, try them all until one works.
Pressing the TV key puts the
remote control in TV mode. Some
or all of the highlighted keys will
be able to control your television.
3 CHECK YOUR RESULTS
If the television advances to the next active
channel, programming is complete! If the
television does not respond, try another 2-digit
code. Some televisions are not listed but can be
programmed.
4 OPERATE YOUR TELEVISION
When you want to control your television, press
the TV key, then try any of the keys shown in the
drawing at left.
• When the remote control is in TV mode, it
WILL NOT operate your VCR.
• To restore VCR mode, press the VCR key.
BRAND CODE(S)
Daewoo.............................. TV + 19
Emerson ............................. TV + 21
Hitachi ................................ TV + 10
JVC .................................... TV + 11
LG ................................ TV + 08, 18
LG (Goldstar)...................... TV + 06
Loewe ................................ TV + 28
Magnavox .......................... TV + 04
Mitsubishi........................... TV + 13
Newsan (S. America) .......... TV + 27
Noblex (S.America) ............ TV + 25
Panasonic ..................... TV + 12, 24
RCA .............................. TV + 07, 29
Samsung .......... TV + 01, 14, 15, 23
Sanyo ........................... TV + 05, 20
Sharp...................... TV + 02, 16, 22
Sony ................................... TV + 03
Telefunken.......................... TV + 26
Toshiba ............................... TV + 09
Zenith ................................. TV + 17
NOTES
• The remote will not operate all brands of
televisions.
• When the remote is in TV mode, it WILL
NOT operate the VCR. Press VCR to restore
normal VCR functionality.