Filter
Top Products
17
Initial Setup
After successfully connecting your DVD Recorder+VCR to your TV and other devices, you are
ready to complete the Initial Setup.
2 - Connections/Setup (cont.)
1
The Welcome screen is displayed. Press
ENTER to continue.
2
Use / to select the desired language
for the Initial Setup, then press ENTER.
3
Use / to select your preferred language
for DVD Disc Menus, then press ENTER.
4
Use / to select your preferred language
for DVD audio soundtracks, then press
ENTER.
• Choose “Default” to always select the
disc’s default audio language.
5
Use / to select your preferred language
for DVD subtitles, then press ENTER.
• Choose “Default” to always select the
disc’s default subtitle language.
• Choose “Off” to always turn off subtitles.
6
Use / to select the type of signal you
are using to watch TV, then press ENTER.
• CATV - if using a Cable TV hookup
• Antenna - if using an Antenna
• Detect Automatically - if you are not
sure
7
Wait for the DVD Recorder+VCR to search
for available TV stations.
• This may take a few minutes to
complete.
8
Set the clock.
• Use
/ to highlight each setting (hour,
minute, etc.).
• Use / to adjust each setting.
• When finished, press ENTER.
9
An information screen appears introduc-
ing the YesDVD feature. Press ENTER to
continue.
10
Initial Setup is complete!
• The DVD Recorder+VCR tunes to the
lowest channel found.
Installation
Welcome.
Press [Enter] to begin auto channel search
.
Ensure antenna is connected
.
Instructions
Setup-Exit
Follow the Installation screens to set up
your DVD Recorder+VCR