Filter
Top Products
5
1
3
Alternate Warnings - This product is
equipped with a three-wire grounding-type
plug, a plug having a third (grounding) pin.
This plug will only fit into the outlet, contact
your electrician to replace your obsolete
outlet. Do not defeat the safety purpose of
the grounding-type plug.
1
4
Power-Cord Protection - Power-supply
cords should be routed so that they are
not likely to be walked on or pinched by
items placed upon or against them, paying
particular attention to cords at plugs,
convenience receptacles, and the point
where they exit from the product.
1
5
Outdoor Antenna Grounding - If an
outside antenna or cable system is
connected to the product, be sure the
antenna or cable system is grounded so
as to provide some protection against
voltage surges and built-up static charges.
Section 810 of the National Electrical Code,
ANSI/NFPA 70 provides information with
regard to proper grounding of the mast
and supporting structure, grounding of the
lead-in wire to an antenna discharge unit,
size of grounding conductors, location
of antenna-discharge unit, connection to
grounding electrodes, and requirements for
the grounding electrode.
1
6
Lightning - For added protection for this
product during a lightning storm or when
it is left unattended and unused for long
periods of time, unplug it from the wall
outlet and disconnect the antenna or cable
system. This will prevent damage to the
product due to lightning and power-line
surges.
1
7
Power Lines - An outside antenna system
should not be located in the vicinity of
overhead power lines or other electric light
or power circuits, or where it can fall into
such power lines or circuits. When installing
an outside antenna system, extreme care
should be taken to keep from touching such
power lines or circuits as contact with them
might be fatal.
Important Safety Instructions (cont.)
1
8
Overloading - Do not overload wall outlets,
extension cords, or integral convenience
receptacles as this can result in a risk of
fire or electric shock.
1
9
Object and Liquid Entry - Never push
objects of any kind into this product through
openings as they may touch dangerous
voltage points or short-out parts that could
result in a fire or electric shock. Never spill
liquid of any kind on the product.
2
0
Servicing - Do not attempt to service this
product yourself as opening or removing
covers may expose you to dangerous
voltage or other hazards. Refer all servicing
to qualified service personnel.
2
1
Damage Requiring Service - Unplug
this product from the wall outlet and refer
servicing to qualified service personnel
under the following conditions:
a When the power-supply cord or plug is
damaged.
b If liquid has been spilled or objects have
fallen into the product.
c If the product has been exposed to rain
or water.
d If the product does not operate normally
by following the operating instructions.
Adjust only those controls that are
covered by the operating instructions
as an improper adjustment of other
controls may result in damage and
will often require extensive work by
a qualified technician to restore the
product to its normal operation.
e If the product has been dropped or
damaged in any way.
f When the product exhibits a distinct
change in performance-this indicates a
need for service.
2
2
Replacement Parts - When replacement
parts are required, be sure the service
technician has used replacement parts
specified by the manufacturer or that have
the same characteristics as the original
part. Unauthorized substitutions may result
in fire, electric shock, or other hazards.
23 Safety Check - Upon completion of any
service or repairs to this product, ask the
service technician to perform safety checks
to determine that the product is in proper
operating condition.
24 Heat - The product should be situated
away from heat sources such as radiators,
heat registers, stoves, or other products
(including amplifiers) that produce heat.
25 Wall or Ceiling Mounting - The product
should be mounted to a wall or ceiling only
as recommended by the manufacturer.