GoVideo VR2940 DVD VCR Combo User Manual


 
39
7 - Help (cont.)
SYMPTOM CAUSE SOLUTION
Can’t play disc
recorded
on this DVD
Recorder+VCR on
another DVD player.
Disc was not finalized (or not made
compatible if using a DVD+RW).
Some players will not play even a
finalized disc.
Discs recorded with copy-once
material cannot be played on other
players.
Finalize disc; see page 27.
No solution.
No solution.
Cannot record or did
not record successfully.
Insufficient blank space remaining on
disc.
Source you are trying to record is
copy-protected.
When setting the recording channel,
the channel is tuned on your TV’s
tuner.
Use another disc.
Cannot record the copy-protected
source.
Select the channel on the DVD
Recorder+VCR’s built-in TV tuner.
Timer Recording not
possible.
Clock not set to correct time.
Timer has been programmed
incorrectly.
TIMER indicator light does not appear
after programming timer.
Set clock to correct time; see page 31.
Reprogram Timer; see page 25.
Reprogram Timer.
No stereo sound
during recording and/or
playback.
TV not Stereo-compatible.
Broadcast program not in stereo
format.
DVD Recorder+VCR A/V Out jacks
not connected to TV A/V In jacks.
DVD Recorder+VCR Audio/Video Out
not selected for viewing at TV.
DVD Recorder+VCR’s TV audio
channel is set to SAP or MONO.
No solution.
No solution.
Make A/V connections. Stereo is
available only via A/V output from
DVD Recorder+VCR.
Select AUX or A/V source as TV input.
Set TV audio channel mode to Stereo.
Press
AUDIO repeatedly to change
the TV Audio Channel.
Remote control does
not work properly.
Remote control not pointed at remote
sensor of DVD Recorder+VCR.
Remote control too far from DVD
Recorder+VCR.
Obstacle in path of remote control and
DVD Recorder+VCR.
Batteries in remote control are dead.
Remote control is locked.
Point remote control at remote sensor
of DVD Recorder+VCR.
Operate remote control within 23 ft
(7m).
Remove obstacle.
Replace batteries.
Press and hold POWER key on front
panel for over 5 seconds.
Troubleshooting (cont.)