Filter
Top Products
USING THE REMOTE TO CONTROL VCR FUNCTIONS
42
USING THE REMOTE TO CONTROL VCR FUNCTIONS
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote
to match the remote system of your VCR. (refer to page 34 for pre-codes)
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. Press and release the VCR button to switch to the VCR pre-coded mode.
4. Hold down the VCR button on the remote, enter the two digit preset code that matches your
VCR, as shown on page 34. The indicator light will flash 3 times if the code was accepted.
5. Aim the remote at the VCR and press the POWER button. The remote will turn off your
VCR when the correct two digit preset code is entered. When this occurs, the remote control
is programmed for your VCR. If the VCR does not turn off, try a different two digit preset code.
6. The remote will now control your VCR.
NOTES:
1. If your VCR cannot be operated after performing the above procedures, your VCR's code
has not been precoded into the remote.
2. In the unlikely event that your VCR cannot be operated after performing the above
procedures, please consult your VCR operating guide.
3. The remote control will remember the codes you have programmed until the batteries are
removed from the remote control. After replacing the batteries repeat the entire programming
procedure as stated above.
4. The LAST CH button will act as your VCR ENTER button if required.
5. The SLEEP button will act as your VCR '100' button if required.
Click here for remote CLU-573TSI.
Click here for remote CLU-574TSI.
(1) VCR Button
This button allows the remote to control your VCR by setting it to VCR mode.
(2) PRECODED VCR Buttons
These buttons transmit the chosen precoded VCR codes. For some VCRs, you must press
the RECORD button twice to record a program.
(3) EXCLUSIVE TV Buttons
These buttons are for operating the TV.
MY VCR CODE IS:___________________