Filter
Top Products
USING THE REMOTE TO CONTROL ADDITIONAL AUDIO/VIDEO
EQUIPMENT
48
NOTES:
1. If your DVD player cannot be operated after performing the above procedures, your DVD
player code has not been precoded into the remote.
2. In the unlikely event that your DVD player cannot be operated after performing the above
procedures, please consult your DVD player operating guide.
3. The remote control will remember the codes you have programmed until the batteries are
removed from the remote control. After replacing the batteries repeat the entire programming
procedure stated above.
(1) DVD Button
This button allows the remote to control your DVD player by setting it to DVD mode.
(2) PRECODED DVD Buttons
These buttons transmit the chosen precoded DVD codes.
(3) EXCLUSIVE TV Buttons
These buttons are for operating the TV.
MY DVD PLAYER CODE IS:___________________
NOTE: Refer to instruction manual of the DVD player for operation of the buttons exclusively
for the DVD player.
USING THE REMOTE TO CONTROL ADDITIONAL AUDIO/VIDEO EQUIPMENT
Operating the precoded function for your Audio/Video component.
This remote is designed to operate different types of AUDIO/VIDEO EQUIPMENT. You must
first program the remote to match the remote system of your AUDIO/VIDEO EQUIPMENT.
(refer to page 37.)
1. Turn ON your AUDIO/VIDEO EQUIPMENT.
2. Aim the remote control at the front of your AUDIO/VIDEO EQUIPMENT.
3. Press and release the AV1, AV2 or AV3 button to switch to AUDIO/VIDEO EQUIPMENT
pre-coded mode.
4. Hold down the AV1, AV2 or AV3 button on the remote and enter the two digit preset code
that matches your AUDIO/VIDEO EQUIPMENT, as shown on page 34. The indicator light will
flash 3 times if the code was accepted.