Filter
Top Products
USING THE REMOTE TO CONTROL ADDITIONAL AUDIO/VIDEO
EQUIPMENT
49
5. Aim the remote at the Audio/Video component and press the POWER button. The remote
will turn off your AUDIO/VIDEO EQUIPMENT when the correct two digit preset code is
entered. When this occurs, the remote control is programmed for your AUDIO/VIDEO
EQUIPMENT. If the AUDIO/VIDEO EQUIPMENT does not turn off, try a different two digit
preset code.
6. The remote will now control your AUDIO/VIDEO EQUIPMENT.
7. Repeat steps 1 - 6 it you wish to program the remote to control another audio/video
component. Be sure to use a different A/V button on the remote, since only one component
can be programmed per button.
NOTES:
1. If your Audio/Video component cannot be operated after performing the above procedures,
your Audio/Video component code has not been precoded into the remote.
2. In the unlikely event that your Audio/Video component cannot be operated after performing
the above procedures, please consult your Audio/Video equipment operating guide.
3. The remote control will remember the codes you have programmed until the batteries are
removed from the remote control. After replacing the batteries repeat the entire programming
procedure stated above.