Filter
Top Products
11 Press the PROGRAM button to set the program in memory.
12 Press the POWER button to turn off the VCR.
The delayed recording indicator will display on the VCR.
This tells you that the VCR will automatically record at the times and dates you have programmed.
• If you are using a cable box, you must select the channel you want to record on the cable box (in this case
8); and turn on the cable box.
Note: You can correct any item entered as you go by pressing the CLEAR button repeatedly until the digit to be
corrected changes to white dash "-" on the screen. Then enter the correct number. Illogical times and dates
won't be accepted.
To stop recording while in the timed recording mode:
1 Press POWER button.
2 Press the STOP button within 10 seconds.
• This can be done either on the VCR or with the remote control.
When you have set up all the timed recordings you want:
• Don't forget to load a videocassette (with the safety tab still attached) to record on.
• If using a cable box the VCR can control, turn on the cable box before the time the recording is to begin.
• If using a cable box the VCR cannot control, turn on the cable box and tune it to the channel you want to
record before the time the recording is to begin.
• If you use a DSS box which can be controlled by the VCR, turn on the DSS box before the time the delayed
recording is to begin.
• If you use a DSS box which cannot be controlled by the VCR, press the AVX button to select LINE 1 in the
step 5, not a channel to be recorded, then turn on the DSS box before the time the delayed recording is to begin
and tune the DSS box to the channel which you want to record.
When the DSS box has been set up and <CATV1> or <CATV2> is
specified for "1 CHANNEL" on the "CHANNEL PRESET" screen
If you have selected one of the channels 100-125 when programming the timer, the following screen will appear.
Example: Programming DSS or CATV channel 120 for delayed recording: